1. Forum
  2. DOVE-Net
  3. Synchronet Discussion

  • Try Synchronet

    From Fernando Miculan@VERT to Todos on Sat Nov 28 13:00:29 2015
    Hola Todos!

    I try Synchronet, how to set up fidonet?
    needed some mailer for route ??

    Actually run elebbs with fmail and Internet Rex, base of msg is JAM. how to migrate synchronet??

    Help me!, i do not where to start.

    p.d: sorry for my english. is very poor. :(

    Saludos!
    .:Fercho:.

    --- FMail/Win32 1.60.GPL
    * Origin: ..:: Fercho BBS ::.. telnet: ferchobbs.ddns.net ..::.. (4:902/19)
    þ Synchronet þ Vertrauen þ Home of Synchronet þ telnet://vert.synchro.net
  • From Wilfred van Velzen@VERT to Fernando Miculan on Sat Nov 28 18:05:06 2015
    Hi,

    On 2015-11-28 13:00:29, Fernando Miculan wrote to Todos:
    about: "Try Synchronet":

    I try Synchronet, how to set up fidonet?
    needed some mailer for route ??

    Actually run elebbs with fmail and Internet Rex, base of msg is JAM. how
    to
    migrate synchronet??

    You could keep fmail and internet rex (or binkd) as frontend tosser and mailer,
    and only replace elebbs with synchronet. But synchronet has it's own messagebase format, so it can't use your current JAM message base, so your synchronet setup should become a (down)link of your frontend setup...

    --- FMail/Win32 1.60.GPL

    You should upgrade! ;)

    Bye, Wilfred.


    --- FMail-W32-1.69.11.142-B20151009
    * Origin: Native IPv6 connectable node (2:280/464)
  • From Al@VERT to Fernando Miculan on Sat Nov 28 13:53:00 2015
    On 11/28/15, Fernando Miculan said the following...

    I try Synchronet, how to set up fidonet?
    needed some mailer for route ??

    Yes, you'll need binkd or something similar to transfer mail.

    Actually run elebbs with fmail and Internet Rex, base of msg is JAM. how to migrate synchronet??

    Internet rex can be used as your mailer if you like. Synchronet uses SMB message bases.. not the same as jam. If you want your current msgbase to be
    in your new synchronet setup you'll have to set it up as a point off your current setup and rescan the areas and have them imported over there with sbbsecho.

    Or mabe you can rescan from your hub, that would save you a whole lot of hullabullu. :)

    Ttyl :-),
    Al

    --- Mystic BBS