Valve Heater delay Drake L-4/4B PA
From
G8MNY@4:902/6 to
WW on Wed Dec 11 05:58:00 2024
To : TECH@WW
By G8MNY (Update Apr 24)
(8 Bit ASCII graphics use code page 437 or 850, Terminal Font) ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ÚÄÄÄÄÄÄÄ¿
³ÚÄÄÄ¿ _ _ ³³ ³
³ÀÄÄÄÙ (_) (_) ³³ ³
³ÚÄÄÄ¿ _ ³³ ³
³ÀÄÄÄÙ (_) ø ø³³ ³
³ o [|]³³ ³
ÀÄÂÂÄÄÄÄÄÄÄÄÄÄÄÂÂÄÙÀÂÂÄÄÄÂÂÙ
This USA made Drake PA as a pair of expensive (RCA=$750ea) 3-500Z valves in it. On these unbiased power triodes, the grid goes quite +ve with resect to the cathode with RF drive.
These have a seperate heater transformer in the PA unit.
To reduce the heater inrush current, that can eventually blow the bright direct cathode filement, I added a 400R NTC 10W Thermistor (ex Valve TV heater chain) instead of the bridging strap of the 2x 115V windings. The thermistor is put in a heat proof silicon sleeving & heatshring on leads, as it is on mains circuit & hot.
CW/tune
LÄo-oÄÄÄÄo/oÄÄÂÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ\ oÄÄÄÄÄÄÄÄÄÄÄ¿_
Fuse 1 on ³ oSSB __)|| _
³ 200VA Heater ³ TUNE³__ ||(
³____ __ ³_____________)||( 850V on
115V)||(__ 5.5V ³__ ||( TUNE mode
400R _________)||(__ 30A )||( or 1.1kV
Therm_________ || __ 115V)||( in SSB Mode
³115V)||( 18V _____)||( @ 2A to
FAN )||(__0.5A [o-o__ ||( the Voltage
ÃÄÄÄÄÙ Fuse 2 )||( Doubler
³ Transformer 115V)||(_
³ in PA _)|| 2.2kW Peak NÄÄÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ HT Transformer
Results is, the heaters now take 4 seconds, rather than 0.5 second to warm up now, & the filement volts have dropped a bit from 5.1V to 5V. But RF power still 800W max on low power HT tune up setting & > 1kW on high. So the heaters are bright (hot) enough!
See my Tech bul on "ALC line for Drake L-4B PA", "PTT Line for Drake L-4B PA" "Drake PA 3-500 valve repair" & "Using 2 HF PAs".
Why Don't U send an interesting bul?
73 de John, G8MNY @ GB7CIP
-----------------------------------------
ARGEN-X BBS - IPV6 TELNET LU9DCE.DYNU.COM -----------------------------------------
--- Mystic BBS v1.12 A48 (Linux/64)
* Origin: ARGEN-X BBS (4:902/6)