• BNOS 12A 13.8V PSU

    From G8MNY@4:902/6 to WW on Sat Jan 4 08:00:38 2025


    By G8MNY (New Dec 12)
    (8 Bit ASCII graphics use code page 437 or 850, Terminal Font)

    I have repaired some these, the 12A (15A meter) & 30A model are similar. ÚÄÄÄÄÄÄÄÄÄÄÄ¿
    ³ ÚÄÄÄÄÄ¿ ³ Current limiting
    ³ ³\ ³ ³ Over voltage Crowbar @ 14.5V
    ³ ³ \ ³ ³
    ³ ÀÄÄÄÄÄÙ ³
    ³ ³
    ³ o o ³
    ÀÂÂÄÄÄÄÄÄÂÂÄÙ

    INPUT CIRCUIT
    The mains transformer's 2 secondaries feed a bridge rectifier & then to the capacitor bank. (the bridge can fail on heavy use)
    __ ___________________
    LÄo-oÄÄo\Ä¿||( \__ / ³+ ³ ³+ +20V
    3A )||(_ / Single === ³+ ===
    )|| _X Bridge ³ === ³3x
    )||( \_Rectifier ³ ³ ³6m8
    NÄÄÄÄÄÄÄÄÄÙ||(__/ \ \__³___³___³________-Ve (0V)
    EÄÄ¿ 2x 17V 10A \ \
    \ À´>ÃÄ´>ÃÄ180ÄÂÄÄÄÂÄÄÄÂÄ+24V
    \AC ³ ³+ _³_ ³u1
    ÀÄ´ÃÄÙ === /_\'=== ON PCB
    + ³ ³24V³
    ÀÄÄÄÁÄÄÄÁÄ0V
    CONTROL CIRCUIT
    +20VÂÄÄÄÄÄÄÄÄÄÂÄÄÄÄÂÄÄÄÄÄÄÄÄÄÄÂÄÄÄÄÄÄ¿
    ³ ³/ ³ ³/ ³/ 2x
    ÚÄÂÄÄÄ)ÄÄÄÂÄÄÄ´TIP120³ ÚÄÄÄÅÄÄÄÂÄÄ´ 2N3055
    ³ ³ ³ ³ ³\e ³/ ³ ³\e ³ ³\e PASS
    ³ ³ ³ _³_ ÀÄÄ´ ÃÄ´ÃÄÄ´ À´ÃÄÄ´TRANSISTORS
    ³ ³ _³_ \_/ ³\e ³ ³ R
    ³ ³ /_\ ³ Driver ÀÄÄÄÄ´ ÚÄ1KÁÄÄRÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ(Amp)ÄÂÄ>+13.8V
    ³ ³ ³ ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ)Ä)ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ2K2ÄÄ¿ ³
    ³ ³ ÃÄÄÄ)ÄÄÄÄÂÄÄÄÄÄÄÄÄÄÄ)Ä)ÄÄÄÄÄÂÄÄÄÄÄÄÄÄÄÄÄÂÄÄÄÄÄÄ)ÄÄÂÄÄÂÄÄ´
    ³ ³ ³ ³ ³ ³ ³ ³ _³_ _³_ ³u1³ ³
    +24V ³ ³ ³ ³ ³ ÚSETIÄÄ)ÄÙ ³ \_/ =\_/ ³ === ³
    ÃÄ¿ ³ ³ ³ ³ ³ ³/e ³ Ú5K1Ä´ ³ red³ ³ ³ _³_
    2³3³8³1³ ³ ³ ÀÄ´PNP u1³ ³ ÚÄÄÁÄÄÄ¿8 ÃÄÄÄÄÄÄ´ 1K ³ /_\
    ÚÁÄÁÄÁÄÁ¿ 18K ³ ³\ === ÃÄ´MC3423ÃÄ¿ SCR_³_ ³ ³ ³ ³
    ³ LM376 ³ ³ \³ ³ ³ ³2ÀÂÄÂÄÂÂÙ ³ \_/ _³_ ³ ³ ³
    ÀÂÄÂÄÂÄÂÙ SET NPNÃÄÂ2K2ÂÁÄÄ¿ ³ ³ 1³8³4³³3 ³ /³ =\_/ ³ ³ ³
    4³5³7³6ÀÂÄ>V e/³ ³ ³+ ³ ³ 1K ÃÄÙ+ÃÙ +Ã100´ ³ Green³ ³ ³ ³
    ³===À´ÃÙ ³ ³ === === 10K ³ ³ ³ === === ===³ 2K2 ³ ³ ³
    ³ ³u1 2K2 ³ u1³ ³10u³ ³ ³ ³10u³10u³ u1³ ³ ³ ³ ³ ³
    ÄÄÁÄÁÄÄÄÄÄÄÄÁÄÄÄÁÄÄÄÁÄÄÄÁÄÄÄÁÄÄÄÁÄÄÁÄÄÁÄÄÄÁÄÄÄÁÄÄÄÁÄÁÄÄÄÄÄÄÁÄÄÁÄÄÁÄÄÁÄ>0V
    Volt Control Current Limit Over Voltage Crowbar

    VOLTAGE CONTROL
    The voltage control IC LM376 runs on a voltage doubled supply of 24V. It compares it's internal reference with the preset SET V & drives the TIP120 darlington to drive the 2 heat sinked pass transistors to maintain the output voltage.

    CURRENT LIMITING
    The 2 pass transistors have current equalising emitter resistors (R), & when one of these is over the base emitter voltage of the PNP, that turns on a NPN to override the LM376 drive, to limit the current.

    OVER VOLTAGE PROTECTION
    IC MC3423 is a triggered over voltage IC that fires the crowbar SCR to short the output if it is too high. Danger here is when charging batteries if the trip should go causing a fire. So use a fuse with battery!


    Why don't U send an interesting bul?

    73 De John, G8MNY @ GB7CIP



    -----------------------------------------
    ARGEN-X BBS - IPV6 TELNET LU9DCE.DYNU.COM -----------------------------------------


    --- Mystic BBS v1.12 A48 (Linux/64)
    * Origin: ARGEN-X BBS (4:902/6)